Hand wash basin / throughs - sensor integrated

Type 20580 / type 20580 -1, -2, -3, -4, -5, -6

Wash basin / through in a hygienic design with a stainless steel rear panel and finely finished hygienic surfaces.

A Dyson Airblade Tap hand dryer is integrated into the outlet fittings to enable hand drying at the basin in just 12 seconds.

No extra hand-drying space required and no splash onto floor surfaces.

Both water and air is controlled by a sensor so no contact is necessary to outlet fittings or control buttons. 

Intelligent infra-red light sources enable precision positioning of hands.


  • 12-second drying time
  • A HEPA filter to remove 99,9% of bacteria from the hand drying air
  • Low operating costs
  • HACCP certified 
  • Low CO2 emissions
  • No splashes on floor surfaces
  • Non-contact operation
  • Reduces water consumption via sensor controlled water flow

Exterior dimensions (D x B x H): 445 x 425 x 746 mm
Outlet tap: Stainless steel with integrated sensor
Drain valve: R11/2"
Thermo-mixing valve (Optional): 1/2", continuously adjustable from 35° C - 65° C
Soap and disinfectant dispenser (Optional):  Plastic or stainless steel versions
Mains supply: 220 - 253 V, 50 Hz
Rarted power: 1,600 W
Control voltage:  24 V DC
Operational temperature range: 0° C - 40° C
Cable cross-section: 3 x 1,5 mm2
Protection class: IP65
Net weight: From approx. 11 to 60 kg
Room temperature: min. + 4°C, max. + 40°C